A messy palette quietly causes muddy paintings. When colors are squeezed out at random, the cadmium red ends up next to the phthalo green, a stray brush drags one into the other, and twenty minutes later every mixture leans gray. Learning how to set up a paint palette is mostly about deciding, before you start, where each color lives and where mixing happens, so your hand goes to the same spot every time.
Quick answer: To set up a paint palette, place colors around the outer edge in a fixed order (most painters go warm to cool, light to dark, with white in its own generous spot), leave the center open for mixing, and keep at least a thumb’s width of space between piles so they do not touch. Squeeze out pea- to grape-sized amounts for acrylic and watercolor, more for oil and white. Use the same layout every session so color locations become automatic.
The steps below work for oil, acrylic and gouache on a flat mixing palette, with notes for watercolor wells. You will find a materials list, timings, three proven layouts, and how to keep paint workable for the whole session.
Materials
- A palette sized for your work: roughly 9 x 12 inches for small paintings, 12 x 16 inches or larger for canvases above 16 x 20 inches. Glass, sealed wood, disposable paper pads, plastic, or a stay-wet palette for acrylic. If you are still choosing one, our guide to paint palette and brush set options compares the common types.
- Your paints, ideally a limited palette to start (see below).
- A palette knife for mixing and moving paint.
- Paper towels or lint-free rags.
- Medium or water in a small cup or palette cup.
- Optional: a gray card or gray paper under a clear glass palette, a spray bottle (acrylic), plastic wrap or a palette lid.
How to Set Up a Paint Palette: Step by Step
Step 1: Choose your palette surface color (2 minutes)
The color under your paint affects how you judge mixtures. A white palette makes colors look darker than they will on a toned canvas; a mid-gray palette gives a more neutral read. Many oil painters put a sheet of neutral gray paper under a glass palette for this reason. If you paint on a white ground, a white palette is fine. Match the palette to the tone of your painting surface when you can.
Step 2: Decide your color order (5 minutes, once)
Pick an order and write it down. Consistency is more important than which order you choose, because the goal is muscle memory. Three reliable layouts are described in the next section.
Step 3: Place white first (1 minute)
White is used in more mixtures than any other color, so it gets the most space and a central edge position, usually near the corner closest to your painting hand. Squeeze out two to three times as much white as any other color.
Step 4: Lay out colors around the edge (3 to 5 minutes)
Working along the top edge (and down one side if needed), squeeze out each color in your chosen order. Keep about 1 to 1.5 inches between piles, roughly a thumb’s width, so wet edges never meet.
Typical amounts per session:
| Medium | Per color | White | Notes |
|---|---|---|---|
| Oil | Hazelnut to walnut size | 2 to 3 times that | Stays workable for hours; you can be generous |
| Acrylic | Pea to grape size | About twice that | Dries fast; replenish small amounts rather than wasting large ones |
| Gouache | Pea size | Twice that | Can be rewetted, but dried gouache handles differently |
| Watercolor (tube) | Pea size into a well | Optional | Can dry in the well and be reactivated |
Step 5: Clear the mixing area (1 minute)
The center of the palette is your mixing field. Leave at least half the palette open. On a small palette, sacrificing a color slot is better than cramming the mixing space, because mixing is where most of the work happens.
Step 6: Premix key values (10 to 20 minutes, optional)
Many painters premix a few strings of value before starting, such as three or four steps of a main color from dark to light. This is especially useful for oil portraiture and landscapes. Premixed piles sit just inside the edge colors so the center stays clear.
Step 7: Set up water or medium and towels (2 minutes)
Place your water jar or medium cup on the same side as your brush hand, and towels just beside it. Every rinse and wipe then takes the same short path. For oil, keep solvent in a closed container with a lid and good ventilation.
Three Palette Layouts That Work
Layout A: Warm to cool (classic)
Colors run around the edge from white, through yellows, oranges and reds, then violets, blues, greens and earth colors, ending with black or a dark neutral if you use one. A typical sequence:
- Titanium white
- Lemon or cadmium yellow light
- Yellow ochre
- Cadmium red light or a warm red
- Alizarin crimson or quinacridone red (cool red)
- Ultramarine blue
- Phthalo or cerulean blue
- Viridian or phthalo green
- Burnt sienna
- Burnt umber
Why it works: neighbors are close in hue, so a brush dragging into the next pile causes only a mild shift instead of mud.
Layout B: Light to dark (value-first)
Colors run from lightest value to darkest along the edge: white, yellows, light earths, reds, mid earths, blues, deep earths and black. This suits painters who think primarily in value, such as tonalist landscape painters, and makes it easy to grab a darker version of any note.
Layout C: Split primaries (beginner-friendly)
Use a warm and a cool version of each primary plus white: warm yellow, cool yellow, warm red, cool red, warm blue, cool blue. Place warm versions on one side of white and cool versions on the other. Six colors and white can mix a remarkably wide range, and the layout teaches color temperature quickly.
Setting Up a Palette for Each Medium
Oil
Oil stays open for hours (and often longer), so you can lay out the full palette at once. Glass or a sealed wooden palette is easy to scrape clean. Arrange medium in a small cup clipped to the edge. When you finish, scrape usable piles to one side; they can last a day or more covered, depending on the pigment and conditions. For cleanup that does not damage brushes or the palette surface, follow our guide on cleaning an oil paint palette and brushes.
Acrylic
Acrylic skins over quickly, often within 10 to 20 minutes on a dry palette in a warm room. Two adjustments help:
- Use a stay-wet palette: a shallow tray with a damp sponge or blotter under a sheet of membrane paper. Paint sits on the moist membrane and can stay workable for hours or days with the lid on.
- Squeeze out less, more often. Put out small amounts and refresh as needed. Mist lightly with water every 15 to 20 minutes on a regular palette.
Gouache
Gouache can be rewetted, but rewetted gouache loses some of its creamy body. Squeeze out small amounts in wells or on a ceramic palette, and add a drop of water to keep them fresh. Arrange as you would for acrylic.
Watercolor
Watercolor palettes usually have fixed wells around a central mixing area, so layout happens once. Fill wells in your chosen order, let tube paint dry in the wells for a day or two, and label them on a strip of tape or a swatch card. Most watercolorists use the warm-to-cool order so adjacent wells mix cleanly.
Keeping the Palette Organized During a Session
A good layout only helps if it stays organized. These habits keep colors clean:
- Mix with the knife, not the brush, for larger quantities. Knives do not carry paint into neighboring piles the way bristles do.
- Pull paint from the edge of a pile. Take from the side facing the mixing area; never dig into the middle.
- Wipe the brush before going to a new color. Especially before touching white or yellow, which contaminate easily.
- Clear the mixing area every 30 to 60 minutes. Scrape old mixtures to a corner or wipe them off so new mixes start clean.
- Keep dark, high-strength pigments apart. Phthalo blue and green are extremely strong; a tiny amount tints everything. Give them extra space.
Choosing a Starter Color Set
Beginners often lay out too many colors. More tubes means more decisions and more ways to make mud. A limited palette of six to eight colors plus white teaches mixing far faster.
| Palette | Colors | Best for |
|---|---|---|
| Zorn-style | White, yellow ochre, cadmium red light, ivory black | Portraits, value studies |
| Basic split primary | White, two yellows, two reds, two blues | General learning, color temperature |
| Landscape | Split primary plus burnt sienna and a green | Outdoor scenes, foliage |
| Extended studio | 10 to 12 colors including earths | Experienced painters with established habits |
Adapting the Layout for Small Spaces and Outdoor Painting
A full studio palette does not always fit. When space is tight, the same principles still apply in compressed form.
- Handheld or thumb-hole palettes: put white nearest the thumb hole, where your hand supports the weight, and run colors around the far curved edge. Keep the area closest to your body for mixing.
- Plein air pochade boxes: the palette is often small, around 8 x 10 to 10 x 12 inches. Cut down to five or six colors plus white and place them along the top edge only, so the whole lower area is mixing space.
- Lap desks and tiny tables: a disposable tear-off palette pad saves cleanup time and lets you start each session on a fresh sheet in the same layout.
- Sharing a palette in a class: agree on the order beforehand and mark each color position with a small dot of dried paint or tape on the edge.
Outdoors, sun and wind dry acrylic very quickly. Shade the palette with your body or an umbrella, squeeze out smaller amounts, and favor oil or a slow-drying acrylic formula if long outdoor sessions are your goal.
Common Palette Setup Mistakes
- Too little white. Running out mid-mix interrupts your flow and changes your values.
- Colors touching. Piles placed too close bleed into each other.
- A tiny mixing area. Cramped mixing leads to small, inconsistent batches.
- Changing the order every session. You lose the speed that comes from knowing where each color is.
- Squeezing out a full tube’s worth of acrylic. Most of it will dry before you use it.
- Ignoring the palette’s tone. Mixing on bright white for a dark-toned canvas can mislead your value judgments.
End-of-Session Routine (5 to 15 minutes)
- Scrape usable oil paint piles together at the edge; cover with plastic wrap or a lid.
- For acrylic, close the stay-wet lid or scrape dried paint off a plastic or glass palette once it peels.
- Wipe the mixing area clean so the next session starts fresh.
- Clean brushes according to the medium, then reshape the tips and dry them flat or tip-up.
FAQs
What order should colors go on a paint palette?
The most common order is warm to cool around the edge, starting from white: yellows, reds, violets, blues, greens, then earth colors. Light to dark is another reliable option. Choose one and keep it the same every session.
Where should white go on a palette?
Give white the largest pile and a central edge position near your painting hand, because it goes into most mixtures. Keep it separate from strong darks so it stays clean.
How much paint should I put on my palette?
For oil, a hazelnut-sized amount per color and two to three times that for white. For acrylic, pea to grape size, refreshed as needed, because it dries quickly.
How do I keep acrylic paint from drying on the palette?
Use a stay-wet palette with a damp sponge and membrane paper, or mist a standard palette lightly with water every 15 to 20 minutes. Squeezing out smaller amounts also reduces waste.
Should I use a white or gray palette?
A gray palette gives a more neutral view of value and color, which helps on toned canvases. A white palette is fine if you paint on a white surface. Many painters place gray paper under a clear glass palette.
How many colors do I need on my palette as a beginner?
Six to eight colors plus white is plenty. A split-primary set (warm and cool versions of each primary) can mix most colors you need and teaches color temperature.
Next Step
A layout is only as good as the palette under it. If yours is too small, stains, or dries acrylic too fast, compare surfaces and sizes in our roundup of the best paint palette and brush sets and pick one that gives your colors room and your mixing area space to work.



